Traktor kontrol s4 controller editor update#

This will be expanded in a future update to implement the Standard Effects Mapping. The button below the mix knob toggles whether the effect parameters are showing on screen. When pressed with shift, they cycle through the available effects. The buttons below the metaknobs control the effect enable buttons. The other knobs control the metaknobs of the effects. The knob on the left of each effect unit controls the mix (dry/wet) knob for all 3 effects in the unit. Hold pressed while moving the jog wheel to finely adjust the loop out point. Hold pressed while moving the jog wheel to finely adjust the loop in point. This is helpful for preparing to mix a track in with a loop. Jump to loop in point, activate loop, and stop playback. Pressing this before a loop will keep playing until the loop is entered. Re-enable a loop that has been set previously. Two dots indicates a loop size larger than 99 beats.Īctivate loop of set size from current positionīeatjump forward/backward by beatjump size (shown on screen but not on controller), or move the loop by beatjump size if there is a loop enabled A dot on the right indicates a fractional loop size. The loop size is shown on the controller. Reset key (if shift is held down increase the range of the BPM sliderĭouble/halve loop size. If sampler is not playing, the loaded track is ejected from the sampler.įast search through track when not playingĮnable slip mode (if shift is held down this decreases the range of the BPM slider, if LOOP RECORDER PLAY is held down enter autoslip mode) If no track is loaded in the sampler, the track selected in the library will be loaded. Load track selected in library to the deck. So if you see or hear clipping, lower the gain of the playing decks adjusting the main volume knob on the S4 will not help. Peak display is only generated from software, however.

Traktor kontrol s4 controller editor software#

The Master Volume knob on the S4 controls the volume of the S4’s main output in hardware, so it does not affect the software main gain knob in Mixxx. GAIN, effects routing, equalizer high/mid/low, and CUE (headphones) behave as labeled. Pressing acts like a double click on the mouse. Up/down will browse in the focused library pane. Best done to fix tracks with the wrong BPM with the pitch fader at 0. Press the encoder to round the track the nearest whole BPM. Increase / decrease the BPM of the track by 0.5. Hold down and press FLUX button on a deck to enable autoslip mode on that deck. This controls the Filter effect by default, but a different effect can be chosen in the Equalizer section of Mixxs’s Preferences. There are some more bonus actions that can be accessed by holding SHIFT and pressing certain buttons. Mixxx does not have remix decks, so the four remix slot buttons control the samplers. Push SHIFT + SYNC to enable Sync Lock for details.

Push and hold the SYNC button to “lock” sync on for all decks you want to remain in sync. Read the Vinyl Control section for details.